Got a Manitowoc Neo. By far am I not hvac related nor work in the industry but i can read a manual and watch some videos and figure some shit out but I’d like you guy’s opinion before i start throwing a shit ton of money into this.
Getting the SL2 code. Pushes water, plate gets cold, but then it starts to get warm after about 20 minutes then throws a fault.
Cleaned the shit out of it, ran the test button, i then noticed the compressor fan wasn’t kicking on at all. I took an air compressor with a tip nozzle and forced it to spin/forced air through the fins.
And the plate got cold as shit and ice started forming. Did it for about 5 minutes straight and it kept making ice. Should I try the jumper trick? Send 110 to the fan see if it spins? Check voltage at the fan connector?
I should add yes the condenser gets hot. Aside from cleaning maintenance, this was used in an air conditioned building with no air issues but dust, and I already blew everything out!
I wrapped up messing with it for the afternoon but want a good direction to head in for tomorrow. Thank yall!
[link] [comments]
No comments:
Post a Comment